Atomium Active Diesel is designed for new / post-overhaul diesel-powered passenger and light commercial vehicles with mileage up to 30,000 miles.
EFFECTS OF APPLICATION
- ♥ Improves the process of an engine burnishing, including condition after overhaul (because of the adaptive properties of the LC, that work on optimization of conjugated friction parts)
- ♥ Increases of the engine life in 1.5 – 2 times (due to wear intensity decreasing)
- ♥ Increases engine effective power (as a result of fuel combustion quality improvement, decreasing combustion gas leakages to carter, and drop of friction losses)
- ♥ Provides maximum engine protection in extreme working conditions, also in case of overloading or overheating and during «cold start-up»
- ♥ Makes start at low temperatures much easier
- ♥ Does not degrade operational characteristics of rubber parts
- ♥ Decreases fuel consumption of internal combustion engine up – to 6 – 8 % (as a result of compression recovering and combustion quality improvement)
- ♥ Decreases noise and vibration levels by 5 – 10 dB (due to forming of thick and resistant lubrication “pillow” and clearances optimization)
- ♥ Decreases exhaust CO/CH emissions up to 50 % (as a result of improvement of combustion quality)
- ♥ Decreases oil waste
- ♥ Significantly reduces the noise of the diesel engine
- ♥ Restores the work of hydro-compensators (tappets)
- ♥ Provides possibility of short – time run under oil starvation conditions or when oil (oil pressure) is completely lost
Important:
- Before applying Atomium Active Diesel shake the can thoroughly until natural sediments (active components) are totally dissolved
- Apply Atomium Active Diesel through the regular oil filling neck of the warmed – up engine
- After applying Atomium Active Diesel the engine should work on single turns (on idle) for 5 min. and then run for no less than 20 min in any mode (regular operation)
- Atomium Active Diesel is compatible with any type of motor oils and does not affect their properties
Dosage
Stages of treatment | The volume of the fillings in the oil sump | |
2 to 7 liters | 7 to 10 liters | |
1st stage | 1 can | 2 cans |
2nd stage | 1 can | 2 cans |
Scheme of treatment by stages | 1 + 1 | 2 + 2 |
Application
The 1st stage: Forming
Add the composition of the lubricant Atomium Active Diesel into a warmed-up engine oil through the oil filler tube. With the vehicle then drive till the next regular oil change (at least 600 miles). In case of significant oil contamination (recognizable by the color of the oil on the dipstick or by oil stains on the filter paper), immediately start with the second phase of treatment.
Recommendations (after the 1st stage): Change oil filter and air filter.
The 2nd stage: Firming
Add Atomium Active Diesel in new engine oil, drive as usual until next oil change
Recommended for maintenance
- For providing continuous level of engine protection it is recommended to apply Atomium Active Diesel Plus at 35,000 – 40,000 miles after the complete treatment with Atomium Active series
- For turbocharged engines and forced engines the re-treatment is recommended after 30,000 miles
- To achieve the full level of protection consider treatment of all vehicle parts such as transmission gears, hydraulic power steering or high pressure fuel pumps & Common Rail Systems etc.